12
Specifications
Adapter Input
AC100V-240V, 50/60Hz
Adapter Output
DC5V=3A
Ports
USB Port*1/HDMI In*1/Audio Out*1/DC In*1
Operating System
Linux
WIFI
2.4G
RAM/ROM
256MB/2G bits
CPU
Mstar V66
Battery Capacity
5200mAh (Rechargeable Li-ion battery)
Display Technology
DLP
Light Source
LED
Resolution
Native 584 x 480
Projecting Distance/Size
0.8/30-110inches
Projecting Mode
Front/Rear/Ceiling
Aspect Ratio
4:3/16:9
Keystone
Auto/Manual ± 40°
Focus
Manual
Troubleshooting guide
1) The content on my iPhone cannot mirrored on the projected screen.
•
Make sure your iPhone is connected to the same 2.4G network as your projector.
•
Go to Setup > Information > Software Version to check the version of your
projector, then contact [email protected] for further assistance.
2) The projector cannot be turned on when I press the power button
•
Connect the projector to the socket with a power cord to check whether the built-
in battery is empty.
•
Make sure you switch the ON/OFF Switch to ON.
3) The projected image freezes or the projector is not responsive.
•
Go to Setup > Advanced to make a factory reset.
4) 3D effect is not working as expected.
•
The 3D active shutter glasses are required.
•
Make sure the 3D video is in the format of side-by-side or top and bottom.
•
Make sure to press the 3D button on the remote.
5) My USB disk or hard drive cannot be read.
•
Make sure the format of your USB disk or hard drive is FAT32 or NTFS.
•
The max. storage of the USB disk should be less than 64GB.
