© Vanderbilt 2017
9
2.2
Wall Mounting
2.2.1
Installing the Bracket
•
The speed dome can be installed to a thread interface or non-thread interface bracket. The non-thread
bracket is highly recommended.
•
When you select a thread bracket, please install the pendent adapter (supplied) between the bracket and
speed dome. Any mismatch problems shall be taken responsibility by the user.
•
For cement wall, you need to use the expansion screw to fix the bracket.
•
For wooden wall, you can just use the self-tapping screw to fix the bracket.
•
Please make sure that the wall is strong enough to withstand at least 8 times the weight of the dome and
the bracket.
•
The wall must be thick enough to mount the expansion screws.
There are several ways to install the speed dome. In this section, the non-thread bracket installation is taken as
an example. Refer to the following steps for details:
Steps:
1. Get the bracket and screws from the packing box as shown follows.
Figure 2-2 Wall Mounting Bracket and Accessories
2.
Drill 4x
12 screw holes in the wall according to the hole locations of the bracket, and then insert M8
expansion screws into the screw holes.
Figure 2-3 Drill Screw Hole and Insert Expansion Screw
3.
Secure the bracket with 4 hex nuts and washers.
Summary of Contents for CCMD2010-OIR
Page 19: ...Vanderbilt 2017 19...
