Vanderbilt ACT365 VCU, Installation And Operating Instructions Manual

Page: 17 / 37

5 Configuring ACT365-VCU
This section describes:
5.1 Accessing the ACT365-VCU web interface 17
5.2 Adding Cameras using Discovery 18
5.3 Adding Cameras Manually 20
5.4 Installing ACT365-VCU on the ACT365 Installer Portal 22
5.5 Associating cameras to doors 23
5.6 Configuring motion detection for a camera 23
5.7 Network Settings on ACT365-VCU 24
5.7.1 Reset the ACT365-VCU hardware to use DHCP 25
5.8 Stream Settings on ACT365-VCU 25
5.9 Factory Reset 26
5.1 Accessing the ACT365-VCU web interface
The ACT365-VCU web interface runs on port 8040 of the ACT365-VCU.
To access the ACT365-VCU web interface:
1. In your preferred web browser, enter http://{NetBIOS name}:8040 (NetBIOS name is printed on the
label on the PCB), or http://{IP address}:8040.
The ACT365-VCU home page may take up to a minute to load.
If you do not know the ACT365-VCU NetBIOS name or IP address, see How do I find the address
of the ACT365-VCU? on page 33.
2. Enter the password and click Login .
The default password is 999999 .
3. If this is the first time you have logged in, you are prompted to change the password. Enter a new
password and click Change .
© Vanderbilt 2019 17 A-100528-b
20.05.2019