www.vanco1.com
800.626.6445
7
Rear Panel
1. INPUTS: Connect HDMI sources to each corresponding HDMI input
2. IR IN:
•
1-4: Connect the included IR Receivers (RXs) to each port, the number on the IR input corresponds to the HDBaseT
outputs. Connect this if you would like to control the display(s) over HDBaseT (receiver(s) have IR outputs)
•
ALL IN: Connect the included IR Receiver (RX) to this port, this will send an IR signal out to all HDBaseT receiver(s);
useful feature to turn on/off all displays at one time
3. IR OUT:
•
1-4: Connect the included IR Transmitters (TXs) to each port, the number on the IR output corresponds to the HDMI
inputs. Connect this if you would like to control the sources from each display location over HDBaseT (receiver(s) have
IR inputs)
•
ALL OUT: Connect the included IR Transmitter (TX) to this port, this will send an IR signal from any HDBaseT receiver
regardless of the HDMI signal routing; useful feature to turn on/off an external amplifier or audio distribution system at
any display location
4. OUTPUTS:
•
1-4 - HDBT: Connect HDBaseT receiver(s) to each output, option of the EVRXHD2 or EVRXDSC PoC receivers
•
1-4 - HDMI: Connect HDMI display(s) via HDMI cable; if needing to extend this signal over Cat6, an HDBaseT extender
is strongly recommended
5. AUDIO MATRIX OUT/ARC: Connect the included 3-pin terminal blocks for analog audio, and four digital
optical outputs for digital audio
•
These audio outputs can either extract audio from the HDMI source(s) connected, or the display(s) over HDBaseT using
ARC. Sources can then be routed to any audio outputs for audio matrix capability
6. RS-232: 3-pin terminal blocks for RS-232 pass-through using EVRXDSC receivers
7. CONTROL:
•
RS-232: Connect the included RS-232 cable to a computer or 3rd party control system for integration
•
IR EYE: Connect the included IR Receiver (RX) to this port, this can be used to control the matrix unit with the included
IR remote; also a helpful feature to hide the matrix unit and lead out the IR Receiver to a different location for remote
control
•
FIRMWARE: Connect a Type-A USB cable to upgrade firmware, any available firmware updates will be located on the
product page for this part # on www.vanco1.com, under the “downloads” tab
•
TCP/IP: Connect to a local network such as a router or ethernet switch to give the matrix unit connectivity, this will give
the ability to control the matrix unit via IP with any device on the network such as a computer, tablet, or mobile phone
8. AC100V~240V: Connect the included power cord for power
9. GROUND: Optional: connect to ground
2
1
3
6
4
5
7
8
9
