www.vanco1.com
800.626.6445
30
9. Firmware Upgrade
Please follow the steps as below to upgrade firmware by the FW port on the rear panel:
1. Prepare the latest two upgrade files and rename them as “08010000.APP” and “08010000.APS” on
PC.
2. Power off the switcher and connect the FW port of switcher to the PC with USB cable.
3. Power on the switcher, and then the PC will automatically detect a U-disk named of “BOOTDISK”.
4. Double-click the U-disk, a file named of “READY.TXT” would be shown.
5. Directly copy one of two upgrade files (e.g. “08010000.APP”) to the “BOOTDISK” U-disk.
6. Reopen the U-disk to check the filename “READY.TXT” whether automatically becomes “SUCCESS.TXT”,
if yes, the firmware was updated successfully, otherwise, the firmware updating is fail, the name of
upgrade file should be confirmed again, and then follow the above steps to update again.
7. Repeat step 5~6 to copy the other upgrade file (“08010000.APS”) to the “BOOTDISK” U-disk.
8. Remove the USB cable after firmware upgrade.
9. After firmware upgrade, the switcher should be restored to factory default by sending command.
To control a local third-party device from remote, first determine which HDBaseT receiver is connected to (1
in the diagram below). Next, connect a PC to the RS-232 port of HDBaseT receiver with 3-pin to DB9 RS-232
Cable, then connect a third-party device (e.g. projector) to the RS-232 port of matrix switcher. The local third-
party device can be controlled by the remote PC; the connection diagram is shown as below:
8.1.4 Control the Local Third-party Device from Remote
