www.vanco1.com
800-626-6445
7
IR CONTROL
Connect an IR receiver to the IR EYE port of the Matrix Switcher, users can control
it through the included IR remote. Here is a brief introduction to the IR remote.
1. Standby button, press it to enter/ exit standby mode.
2. Input channels, range from 1~4, corresponding IR signal switched synchronously
when switching input channels.
3. Outputs: In normal mode: output channel selection buttons.
4. Menu buttons: ALL, EDID, CLEAR and ENTER. ALL: Select all outputs. EDID
management button: Enable input port to manually capture and learn the EDID data
of output devices. CLEAR: Withdraw an operation like switching output channel,
learning EDID data before it comes into effect. Meanwhile, the matrix will return to
the previous status. ENTER: Confirm operation.
Note: With this IR remote, the Matrix Switcher can be controlled by the built-in IR,
the extended IR receiver connected to the IR EYE and the IR receiver on the far-end
receiver.
By using IR & HDBaseT transmission technology, the 4K Home Distribution Hub
Kit has some functions as follows:
1) Control far-end output device from local
2) Control local input/output device remotely.
3) Control the Matrix Switcher locally/remotely.
Switching I/O connection
1.To convert one input to an output:
Example: Input 1 to Output 3: Press INPUTS 1 + OUTPUTS 3 + ENTER
NOTE: Default status, on first boot up this matrix assigns the IR outputs to the corresponding HDMI input, meaning,
IR out 1 is directly associated to HDMI input 1 and so on. When you switch an HDMI input to a different output, the
corresponding IR OUT will be switched synchronously to allow the IR commands to be sent from the select zone back
through the Matrix Switcher to the source.
2. To convert an input to several outputs:
Example: Convert Input 2 to Output 3 and 4: Press INPUTS 2 + OUTPUTS 3 + OUTPUTS 4 + ENTER
3.To convert an input to all outputs:
Example: Input 1 to all Outputs: Press INPUTS 1 + ALL + ENTER
EDID Management
The HDBT4X3 features EDID management that enables the Matrix Switcher to learn the EDID of all sink devices. The
Matrix Switcher can learn the EDID from any device or be programmed to assign an EDID to the mirror port through
EDID Invoking.
1.EDID Learning (from output):
One input port learns the EDID data of one output port:
Example: Input 2 learns EDID data from output 4: Press EDID + INPUTS 2 + OUTPUTS 4 + ENTER
All input ports learn EDID data from one output port:
Example: all input ports learn EDID data from output 4: Press: EDID + ALL + OUTPUTS 4 + ENTER
