AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 1: SAFETY
090034-OP_r0
PAGE - 15
Have only qualified persons familiar with electronic
equipment perform this installation.
The user is responsible for having a qualified electrician
promptly correct any interference problem resulting from
the installation.
If notified by the FCC about interference, stop using the
equipment at once.
Have the installation regularly checked and maintained.
Keep high-frequency source doors and panels tightly
shut, keep spark gaps at correct setting, and use
grounding and shielding to minimize the possibility of
interference.
1.7.9
ARC WELDING CAN CAUSE
INTERFERENCE
Electromagnetic energy can interfere
with sensitive electronic equipment such
as microprocessors, computers, and
computer-driven equipment such as
robots.
Be sure all equipment in the welding
area is electromagnetically compatible.
To reduce possible interference, keep weld cables as
short as possible, close together, and down low, such as
on the floor.
Locate welding operation 100 meters from any sensitive
electronic equipment.
Be sure this welding machine is installed and grounded
according to this manual.
If interference still occurs, the user must take extra
measures such as moving the welding machine, using
shielded cables, using line filters, or shielding the work
area.
1.8
CALIFORNIA PROPOSITION 65
WARNINGS
Welding or cutting equipment produces fumes or gases
which contain chemicals known to the State of California
to cause birth defects and, in some cases, cancer.
(California Health & Safety Code Section 25249.5 et
seq.)
Battery posts, terminals and related accessories contain
lead and lead compounds, chemicals known to the State
