SECTION 2: DESCRIPTION
AIR N ARC
®
200 SERIES ALL-IN-ONE POWER SYSTEM
®
page - 30
090019-OP_r0
Do not
force the reset buttons if they remain fixed in their
inset positions—if the buttons are tripping frequently, or
do not reset, this is an indication of a system problem.
Whenever a circuit breaker trips, always check the
complete system for any possible faulty conditions before
resetting the system. If trouble persists, consult
Section
7, Troubleshooting
, or the Vanair
®
Service Department.
2.5.6 AC VOLTAGE OUTLETS
The
AC voltage outlets
allow for AC generator power
access via one 120V duplex, and one 240V receptacles.
2.5.7 GENERATOR CONTROL ON/OFF TOGGLE
SWITCH
The
generator control ON/OFF switch
engages the AC
generator. When off, the outlets are de-energized.
2.5.8 DC CHARGER MODE TOGGLE SWITCH
The three-position
DC charger mode toggle switch
lets
the operator choose the type of charge needed from 12V
center (default), 12V boost or 24V boost options. This is
a momentary switch; the lights will indicate the mode
selected.
2.5.9 VOLTS/AMPS MANUAL ADJUSTMENT DIAL
The
volts/amps manual adjustment dial
allows the
operate to manually increase or decrease the amount of
amperage or voltage, in variable increments, for the
desired weld heat. Range is: 30-205 amps / 15-40 volts.
2.5.10 COMPRESSOR AIR GAUGE
The
compressor air gauge
indicates the discharge air
pressure.
2.5.11 BATTERY CABLE RECEPTACLE
The
battery cable receptacle
junction contains the
interface connections for the battery cables when
charging the battery from the DC charger. The battery
cable receptacle contains a weather-resistant cap.
2.5.12 WELDER LEAD CONNECTION
The
welder lead connection
contains the positive and
negative interface connections for the standard welding
lead cable.
