SECTION 6: MAINTENANCE
AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
PAGE - 66
090012-OP_r0
to assist the customer in establishing a maintenance
routine log.
For assistance in obtaining routine maintenance or
replacement parts, consult
Section 9.1, Parts Ordering
Procedure
, and
Table 9A: Recommended Spare Parts
List.
6.4 REPLACEMENT PARTS
Replacement parts should be purchased through your
local Vanair representative or where the 300 Series
Power System was purchased. If, for any reason, parts
are not available in this manner, they can be purchased
through Vanair directly.
VANAIR MANUFACTURING, INC.
10896 West 300 N.
Michigan City, IN 46360
Telephone: (800) 526-8817
(219) 879-5100
Service Fax: (219) 879-5335
Parts Fax: (219) 879-5340
Sales Fax: (219) 879-5800
www.vanair.com
6.5 MAINTENANCE ACCESS
Although many of the maintenance requirements of the
Air-N-Arc 300 Series machine package can be accessed
via the hood or the lift out panel at the front, there are
some components that may be difficult to reach, due to
the design of the package. Maintenance issues in such
locations are best accessed by removing the
maintenance access panel assembly, consisting of the
back panel [
G
], hood [
H
] and connected right-side panel
[
J
] as found in
Figure 6-2
.
NOTE:
Removing the back and right-side panels
(maintenance access panel assembly) allows direct
access to perform maintenance as found in the chart on
page 68:
NOTE
For assistance when ordering new
replacement parts, consult
Section 9.1,
Parts Ordering Procedure
, and Table 9A:
Recommended Spare Parts List.
NOTE
If additional spare parts are being stored
for future use, make certain that they are
stored in proper containers that allow for
protection against contamination, and
kept in a clean area of moderate
temperature reading. For information on
storing the machine package for periods
of non-use, consult
Section 6.8.2, Long
Term Storage
.
