15
User manual
Easy Go 16.05
2. Degree of support 1, 2 and 3
The desired support can be set by using one of the support levels 1, 2 or 3.
1. Light support, maximum range.
2. Average support, average range.
3. Maximum support, low range.
You can change the level while cycling.
3. Start assist
The start assist is not available with the Easy Go scooter bike.
4. Battery indication lights
The level of charge in the battery is given by five LED lights: four of these are green,
the one on the left can show either green or red, if charge is low.
The battery is almost empty if only the last red LED light is on. The battery needs to
be recharged or replaced by a (new) fully charged battery.
When the last red LED light flashes, the battery is empty and the motor will no longer
support while cycling. The integrated lighting continues to work.
Never leave the scooter bike with an empty battery!
Note: charge the battery within one day.
When the motor is not used for several days, the battery switches into the
sleeping mode. This is to protect the batteries. To activate it, you can press
the on/off button [A] on the battery and the indication lights will light up. You
also can connect the battery to the charger for a few seconds or cycle the
bike forwards (around 10 km/h) and push the on/off button to activate the
system.
If you push the bicycle, turn off the motor.
If your battery is equipped with a button and indicator lights, the charge-level in the
battery can be checked by pressing the button briefly. The five green lights indicate
the level of charge in your battery, the left one of these, if flashing, given the lowest
level. While charging the battery, these lights will also indicate how far the charging
has progressed.
[A]
