13
Fig. 3: Front Wheel quick release
Install Front Wheel
•
Most deliveries of the Ranger
ST electric cycles will arrive with
the front wheel mounted.
• In the rare case that it does not
come attached, put the front
wheel in the middle of the front
fork.
• Make sure the brake disc is
placed in the center of the
caliper gap and the front wheel
can rotate freely without any
noise. When the brake disc is
not in the gap, DO NOT pull the
Fig. 2: Headlight
Install Headlight
•
The Ranger ST headlight will come
installed, however, removal and
reinstallation can be done easily.
•
You can adjust the height and angle by
loosening the bolt and nut, making the
adjustment and then fastening the bolt
back.
•
Connect the light power cable by
connecting the cables identified with red
insert end.
brake lever.
•
Install the front wheel and tighten the nuts provided. If your cycle
has a quick release, adjust and close tightly.
•
The fasten torque of the front wheel should be no less than 35-40
N.m. (no less than 35-40 N.m. for the rear wheel as well).
Summary of Contents for RANGER ST
