www.valuehobby.com/stylus-sport-60.html
- 6 -
Section 1: Aileron Installation
Required Parts and Hardware:
Wing panels
Ailerons
Hinges 8pcs
Step1. Locate the left aileron and four hinges. Slide
the hinges into the precut hinge slots in the leading
edge of the aileron. Saturate each of the hinges with
thin CA. Make sure to glue both the top and bottom.
Step2. Slide the aileron and wing together through
the hinges. There should have a little gap between
them.
Step3. Deflect the aileron down. Use the thin CA to
saturate the hinges.
Step4. Repeat the previous step to finish the right
aileron installation.
Section 2: Aileron Servo Installation
Required parts and hardware:
Wing panels
Servo hatch 2pcs
Servo mounting blocks 4pcs
Self-tapping screw M2.5*8 mm (.3in) 12pcs
Aileron servo 2pcs (sold separately)
Servo extension 2pcs (sold separately)
Step1. Use the hobby knife to remove the covering
for the servo opening in the bottom of the left wing.
Step2. Install the grommets and eyelets, and servo
arm on the servo. Position the servo on the hatch so
the arm is centered in the notch. Once satisfied, use a
felt-tipped pen to mark the location for the servo
mounting blocks.
