www.valuehobby.com/stylus-sport-60.html
- 16 -
Step27. Center the elevator and servo arm. Attach the
pushrod to the pushrod connector.
Step28. Install the rudder control horn to the rudder.
Step29.Center the rudder and rudder servo arm.
Attach the pushrod to the servo arm through the
connector as shown.
Section 8: Engine Installation
Required parts and hardware:
Tank assembly 360cc
Engine mount 1 pair
Phillips roundhead screw M4*25mm (1.0in) 4pcs
Washer Φ4 4pcs
Step1. Attach the engine to the firewall with four
M4*25mm (1.0in) roundhead screws.
Step2. Position the engine on the mount, adjust the
engine so that the distance between the firewall and
drive washer is 140mm (5.5in). (In this step, attach
the pushrod to the throttle arm and thread the
pushrod through the hole in the firewall.)
Step3. Mark the location for engine mounting bolts.
Drill the holes on the mark and install the engine on
the mount using the screws provided with the engine.
