SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
10
3.4 Using a 7/16” wrench,
unscrew the bolts that hold
the control panel against the
frame and remove it entirely
from the generator.
5.1 Lift the generator up with the alternator plastic cover
facing upward. Using two 1/2” wrenches, separate the
alternator support from the frame.
5.2 Loosen the nut on the anti-vibrating neoprene to
remove it from the alternator.
4.1 Using a two 1/2” wrenches, unscrew the bolts that
hold the muffler heat deflector to the alternator followed
by the muffler/alternator support. Next, unscrew all 6 bolts
(3 above and 3 below the muffler) that hold the muffler
housing and then remove the housing. Finally unscrew the
nuts that hold the muffler heat deflector to the side of the
alternator to remove the heat deflector.
4
5
AlTERNATOR dISASSEMBlY
MUFFlER dISASSEMBlY
4.2 Using a 1/2” wrench, unscrew the two bolts that hold
the manifold and the muffler together and remove the
muffler.
3.3 Separate the control panel
cable housing from alternator
wire housing and remove
each one of the cables from
the receptacle housing. Do
this carefully using a very
small flat screwdriver. Finally,
unscrew the control panel
ground terminal using a
(Phillips) screwdriver.
3.3
3.4
4.1
4 .2
5.1
5.2
