7
Owner’s Information
Thermocouple
probe must be
in flame
Correct
fl
ame appearance
With Logs
With Coals
With Rocks
7.
If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
8.
Reinstall the front and barrier screen.
Checking Pilot and Burner Flames
A periodic check of the pilot and burner
fl
ames should
be made. Check after the
fi
re has been on for at least
30 minutes. The pilot
fl
ame must cover the tip of the
thermocouple probe. The main burner
fl
ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl
ammable vapors and liquids. Inspect the vent terminal
outdoors regularly to make sure that dirt, snow, insects,
leaves, shrubs, trees do not obstruct it. Examine the
whole vent system regularly. We recommend annually.
Using Handset Wall Holder
Your
fi
replace equipment includes a wall
holder to store the handset. If it hasn’t be
installed, refer to the instructions further
on in this manual for the installation.
Replacing Batteries
Low battery signal: see page 13.
BEFORE changing the batteries, turn off the valve
using the manual On/Off switch —
see instructions on
next page.
The appliance uses four 1.5 V AA
alkaline
batteries for
its remote control receiver and one 9 V
alkaline
battery
for its handset. The batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off-season will extend the battery life. Should the
batteries loose power, the control may be operated by
manually turning the control knob at the valve or by
turning off the valve at the switch.
To replace the batteries in the remote control
receiver
:
1. The receiver is located to the left of the valve and it
is retained to the
fi
rebox by a
Velcro
tab. Grab the
receiver and pull it out from its location.
2. Slide and remove the receiver cover.
3. Replace batteries with 4 AA
alkaline
batteries.
4. Replace the cover.
5. Put the receiver back in its position pushing it in so
it attaches to the
Velcro
tab.
Safety warning plate
CAUTION
DO NOT USE
a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
WARNING
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT!
Let
the
fi
replace cool
fi
rst before touching it.
!
WARNING
F O R S A F E T Y P U R P O S E , ensure the
barrier screen is re-installed on the
fi
replace
front after maintenance.
!
OWNER’S
INFORMATION
