Owner’s Information
Turning your fireplace OFF
Press the (small flame) button to reduce the flame to pilot.
Press the OFF button to turn the pilot off.
Alternately, you can press the
O
button on the switch if you won’t use your fireplace for a long period of time, if you cannot
locate your remote control handset or if you wish to change the batteries.
1.
Operation Modes
STANDBY MODE—Ignited pilot only.
man
MAN MODE—Manual Mode. You can use this mode to adjust the flame height up or down.
☼
temp
TEMP MODE—Daytime Temperature Mode (appliance must be in Standby mode; pilot ignited): The room temper
-
ature is measured and compared to the set temperature. The flame height is then automatically adjusted to achieve the
Daytime set temperature.
☽
temp
TEMP MODE—Nighttime Setback Temperature Mode (appliance must be in Standby mode, pilot ignited): The room
temperature is measured and compared to the Nighttime Setback temperature. The flame height is then automatically
adjusted to achieve the Nighttime Setback temperature.
timer
TIMER MODE—(appliance must be in Standby mode, pilot ignited): The Timer setting allows you to set two burner
ON times and two burner OFF times for every 24-hour period.
Changing the Mode of Operation
Briefly pressing the
SET
button changes the mode of operation in the following order:
man
→
☼
temp
→
☽
temp
→
timer
→
and back to
man
.
NOTE: MAN mode can also be reached by pressing either the or buttons.
Mode
Sun
☼
Moon
☽
TEMP
Daytime temperature setting
Nighttime temperature setting
TIMER
Start time setting
Stop time setting
Flame Height
The flame height can be adjusted in the following manners. In STANDBY mode,
Press the (large flame) button to turn on the main burner.
Press the (large flame) button to increase the flame height.
Press the (small flame) button to decrease the flame height or to go to pilot Standby position.
For fine adjustments, tap the
and
buttons.
Quick Flame Adjustment
If or are pressed for 0.5 sec., the flame will increase to maximum or decrease to the pilot Standby position.
NOTE: While pressing either button, a symbol indicating transmission appears on the upper right hand corner of the dis
-
play. The receiver confirms transmission with an acoustic signal.
1.
.
.
