19
Install Gas Pipe & Connector
The gas pipe, connector, clamp and
fi
xing screw are
supplied with the engine.
The support bracket for the gas pipe is supplied with
the stove casing.
Install Receiver into Position
Once the gas pipe is
fi
tted, clip the receiver on top of
the casting corssbar on the base, to the left hand side
of the valve. Make sure the receiver box is oriented with
its wires towards the back and its
RESET
button at the
front.
Installation
Vent Outlet
Convert Vent Outlet
(if necessary)
Rear Vent
If the appliance is to be vented from the top, it is ready
for vent installation once the engine is on the casting
base.
If the appliance is to be vented from the rear, it must be
converted. Follow these simple steps:
1. Remove the following parts in this order:
a. Dura-Vent collar, gasket and intake plate from
the top of the appliance (22 screws of the intake
plate and 2 rear screws of the collar);
b. Exhaust collar (8 screws). Note that the gaskets
are glued to the appliance or the intake plate; it
is not necessary to separate them from the parts
they are attached to. However, if they need to be
manipulated,
BE CAREFUL not to damage them
because their material is fragile
.
2. Reinstall through the vent opening at the rear of the
fi
rebox in the reverse order in which you took the
parts out.
Co-Linear (Rear Outlet ONLY)
For conversion of rear outlet collar to co-linear (two
3-inch pipes) rear venting, refer to instructions
packaged with the 556CLA—Co-Linear Adapter.
NOTE
The support bracket used on Madrona Traditional
stoves and the one used on Madrona Modern
stoves are different. Refer to stove casing
installation manual for complete details.
3/8” gas line
connection
Flare
fi
tting
Receiver clipped to crossbar in
fi
nal position
Receiver & clip
