51
Installation
Replacing Light Bulbs
Lighting
This appliance is equipped with decorative lighting
located above the fuel bed.
Test this overhead lighting before completing installation
(see “Appendix B - Remote Control Operation” on page
66). If any of the bulbs are out, replace them using the
following steps.
Required Bulbs
The light bulbs in the LX2 are 120V, 20W bi-pin (JC)
halogen bulbs GY6.35. A total of 3 are installed in the
unit.
Remove Barriers and Windows
Changing the light bulbs requires access to the inner
fi
rebox. See “Window Sill & Window” on page 26 for
details on removing the windows from the
fi
replace.
Change Bulbs
Wear gloves when changing these bulbs.
Most manufacturers recommend never
touching them as oil from your skin can
shorten their life.
1. Gently pull the bulb out of the receptacle in the
lighting rail.
2. Replace with a new bulb. Be careful to align pins with
the receptacle holes.
3. Test the lighting with the remote control handset
before replacing windows (lighting can operate
independent of main
fi
re being on or o
ff
).
4. Reinstall windows and barrier screens following
steps in section “Window Re-Installation” on pages
52 - 53.
Lighting rail on both sides, just behind window
Position of 3 light bulbs looking up in the
fi
rebox
