49
Rocks & Shale Set 1714RSS
Material required
• Rock & Shale Set, which contains:
• 1/2lb-bag of 3/4” grey shale
• 1/2lb-bag of 3/4” black shale
• 5 twigs
• 34 rocks
Installation
Carefully unpack the kit.
1. Mix the black and grey shale pieces and spread
them by hand in one layer thick on top of the burn-
er.
Do not pour from the bag and do not over
fi
ll to
avoid blocking burner ports!
NOTE:
Ensure the areas
within
the pilot shield, on
the pilot shield and in pilot safe zone are clear of
shale.
Do not put rocks on the pilot shield!
2. Place rocks around the shale bed as indicated.
These rocks will be used to support the twigs.
The rocks used is not important.
Pilot shield
Pilot safe zone
3. Place the twigs on the rocks as shown.
Note:
The position of the twigs are speci
fi
c to obtain
the best
fl
ame pattern. The twigs should not rest
fl
at on the shale bed. Their position across the shale
bed allows some air underneath.
a. Place the one of the curvy twigs as indicated.
b. Place a short Y twig on the rocks behind the pilot
shield; rest the other end on the shale bed.
Fuel Beds
Installation
