Remote Control Initial Set-up
The receiver and the handset of the remote control
system must be initially synchronized before the
fi
rst
use.
1. Remove the cover of the battery box (1 screw).
2. Insert alkaline batteries in the battery box and
handset.
3. Re
fi
t the cover and secure with the screw.
4. On the left hand side of the
fi
rebox, pull the loose
wire that is already connected to the receiver and
connect it to the battery box. Place the battery box
upside on the left of the
fi
rebox.
Battery box connection
Reset
button
Battery box
Remove cover
Connect battery box to wire
5. With a sharp object, press and hold the receiver’s
reset button until you hear one short and one long
beeps. Release the reset button after the second
beep.
6. Within the subsequent 20 seconds, press the (small
fl
ame button ( ) on the remote handset until you
hear two short beeps con
fi
rming the synchronization
is set.
This is a one time setting only and is not required when
changing the batteries in the remote receiver. The
remote control system is now ready to use.
Battery
box
24
INSTALLATION
