Valor LEGEND G3 739JN, Installation & Owner'S Manual

Page: 10 / 46

Remote Control Operation
When the pilot is off, it will take 2
minutes before it can be lit again.
TO TURN ON APPLIANCE TO TURN OFF APPLIANCE
FLAME HEIGHT ADJUSTMENT
• On the valve, turn MAN knob on the ON, full
counterclockwise position.
• Place ON/OFF switch (if equipped) in I (ON
position).
STANDBY MODE (Pilot Flame)
• Press and hold (small fl ame) to set appliance at
pilot fl ame.
• Simultaneously press the OFF and
(large fl ame) buttons until a short
beep con fi rms the start sequence
has begun; release buttons.
• Continuing beeps con fi rm the
ignition is in process.
• Once pilot ignition is con fi rmed,
there is main gas fl ow.
• After main burner ignition the
handset will automatically go into
manual (MAN) control mode.
• Press OFF button.
When the pilot is off, it will take 2
minutes before it can be lit again.
• In standby mode: Press and hold
(large fl ame) button to increase
fl ame height.
CAUTION
When pilot ignition is con fi rmed, motor turns
automatically to maximum fl ame height.
NOTE: Before using the remote control system for
the
fi rst time, the receiver and the handset must be
synchronized. See the section
Remote Control Initial
Set-up
on page 36 of this manual.
Set
(scrolls
through
modes and
settings)
OFF
(returns
to set mode,
turns the burner
and the pilot off )
Large flame
button (flames
up, sets hours,
temperature)
Small flame
button (flames
down and off,
sets minutes,
temperature)
Current
temperature
(F or C)
Current time
(12 or 24 hour clock)
Modes (Manual,
Temperature, Timer)
Handset
sensor
Battery status
Current
programmed
period (Timer)
Period
start or end
(Temp, Timer)
Display Overview
Handset Overview
Note: In the TEMP or TIMER modes, the remote
handset senses the room temperature and adjusts the
fl ame accordingly.
To communicate, the handset should be within 15 feet
(4.5 meters) of the
fi replace.
Do not leave the handset on the mantel or hearth.
IMPORTANT:
BEFORE YOU BEGIN, please note that
on this system, the settings of time, temperature and
automatic ON/OFF can only be programmed when
the function display is fl ashing. Be patient when
programming as it can take a few seconds to set.
10
OWNER’S
INFORMATION