Valor Legend G3 738 NGK, Owner'S Manual, Page: 9 / 24

9
ON:
parallel
to pipe
OFF:
perpendicular
to pipe
Operating your fireplace
Fireplace control devices
There are two ways to control your fi replace.
1. Thermostatic Remote Control turns fi re ON
and OFF, controls fl ame height and can be pro-
grammed to function automatically.
2. Wall Switch (optional) turns fi re ON and OFF, and
controls fl ame height.
Turn your fi replace ON
Press and hold:
- + ( ) on remote, or
- ON-OFF button on wall switch
until a short beep con fi rms the start sequence has
begun; release button(s).
The fi replace beeps twice to con fi rm the ignition is in
process.The pilot lights up, followed by the fi replace.
If you need to light up the pilot manually, see the
Fireplace and Lighting Information card attached to
the fi replace - see page 7 to learn how to access it.
Also, a copy of this card is reproduced in Appendix A
of the Installation Manual.
Turn your fi replace OFF (including pilot)
Press and hold:
- on remote, or
- ON-OFF button on wall switch
If the fl ames or pilot are on, they will go out and you
will hear the valve motor wind down. You will hear
a clunk and a beep indicating that the valve has
received the signal from the remote control.
In the unlikely event that you cannot turn o
ff your
fi replace with the remote control handset, use the
optional wall switch. If the wall switch malfunctions
and will not turn o ff the fi replace, wait 8 hours and
the fi replace will automatically go to pilot. You can
then access the controls inside your fi replace, once it
has cooled.
Alternatively, you may turn o ff the house gas supply.
In all cases, call your dealer for service assistance.
To use additional functions of your Remote
Control such as temperature or program
settings, see Appendix A–Remote Control
Operation on page 21 of this manual or visit
valor fi replaces.com/remotes
Remote Control Wall Switch (optional)
WARNING
STOP IF YOU SMELL GAS! DO NOT LIGHT!
See cover page immediately!
WARNING
Risk of severe burns! Surface of the
fi replace are very hot during operation!
Ensure fi replace has cooled o ff before
accessing control.