Rotate anchor up and
insert panel
Position of panel in
relation to burner plate
Edge of
burner plate
Side panels
should be
parallel to
edge of
burner plate
Port cover installed
Install Liner Panels
The following guidelines apply for all liners.
1. Inside the
fi
rebox, on the top of each side, release
the screw of the side brick anchors (one per side)
just enough to allow them to rotate.
2. Place the rear panel against the back of the
fi
rebox,
on the ledge at bottom.
3. Rotate the anchor up and out of the way and slide
the left hand side panel against the
fi
rebox side.
The panel should be parallel to the edge of the
burner plate.
Rotate the anchor back down to hold
the panel.
4. Rotate the anchor up and out of the way and slide
the right hand side panel against the
fi
rebox side.
The panel should be parallel to the edge of the
burner plate.
Rotate the anchor back down to hold
the panel.
5. Tighten the side brick anchors on each side of the
fi
rebox.
6. Install the port cover
fi
xing it using the two screws
already in the
fi
rebox top.
Installation
QUALIFIED
INSTALLER
25
