Ceramic Bricks Installation
The following guidelines apply for all brick liners.
1. Inside the firebox, on the top of each side, release
the screw of the side brick anchors (one per side)
just enough to allow them to rotate.
2. Place the rear panel against the back of the firebox,
on the ledge at bottom.
3. Rotate the anchor up and out of the way and slide
the left hand side panel against the firebox side.
Rotate the anchor back down to hold the panel.
Ceramic Logs Installation
Unpack the ceramic logs very carefully to avoid damaging the fragile material. Install the logs as shown below.
Please note that the position of the Logs is critical to insure proper performance of the appliance.
1. Spread the decorative charcoals on each side of
the log tray, covering the sheet metal as shown.
DO NOT PUT ANY DECORATIVE CHARCOAL
PIECES WITHIN THE PILOT
SHIELD AREA.
4. Rotate the anchor up and out of the way and slide
the right hand side panel against the firebox side.
Rotate the anchor back down to hold the panel.
5. Tighten the side brick anchors on each side of the
firebox.
6. Install the port cover fixing it using the two screws
already in the firebox top.
15
