8
4.3
LEAK TESTING
All piping and connections must be tested for leaks after
installation or servicing.
All leaks must be corrected immediately.
When testing for leaks:
1.
Make sure that the appliance control knob is at the
off
position.
2.
Open the manual shut-off valve.
3.
Test for leaks by applying a liquid detergent or soap
solution to all joints. Bubbles forming indicate a gas
leak.
DANGER! NEVER USE AN OPEN
FLAME TO CHECK FOR GAS LEAKS
4.
Correct any leak immediately.
4.4
THERMOSTAT SHAFT RECONNECTION
1.
Turn the thermostat
control wheel fully
counterclockwise to
the lowest setting
(position 1). Turn the
thermostat spindle
fully
counterclockwise. See
figure 17.
2.
Release the lower
shaft from its parked
osition. Replace the
collar over the end of
the shaft with the “D”
hole at the bottom.
3.
Swing the shaft and
collar over the thermostat spindle.
Rotate the collar so that the “D” lines up with that in
the spindle and allow the collar to drop fully over the
thermostat spindle.
4.
Refit the “R” clip. The collar will have to be raised
slightly to align the holes. If it is not raised, the clip
may go below the end of the shaft. Check that the
collar rotates when the thermostat control wheel is
turned.
5.
REFIT THE FRONT FRAME
Place the front frame back in position and attach it to the
appliance case with the four screws previously removed.
6.
FIT THE FUEL BED
1.
Place the ceramic back wall in position at the back of
the firebox. Make sure that the brick pattern is the
right way up so that it will align with the side walls
pattern. See figure 18.
2.
Place the ceramic side walls in position at the sides of
the firebox. The sides are left and right handed. The
sides should be held in position at the top by the
angled brackets at the sides of the firebox and at the
bottom by the edges of the black bar at the front of
the firebox. See figure 19.
3.
Place the rear log in the retaining cradle behind the
rear burner rail. See figure 20.
4.
Place the center log in the retaining cradle between
the rear and front burner rails. See figure 21.
5.
Place the two front logs in position on the front log
support tray. It may be necessary to raise the center
log slightly in order to fit the left front log. Make sure
that the spacer blocks positioned on the back surface
of each front log rest against the front face of the
center log at the far left and right positions. See
figure 22.
Check that the fuel bed parts are secure.
Figure 17
Figure 18 Ceramic Back Wall
Figure 19 Ceramic Side walls
Figure 20 Rear Log
Figure 21 Center log
Figure 22 Front logs
