53
Slide the battery carrier
out of the appliance
Battery box
connection
Reset
button
Velcro
Initialize Remote Control
The receiver and the handset of the remote control sys-
tem must be initially synchronized before the
fi
rst use.
1. Insert one 9 V
alkaline
battery in the handset.
2. Locate the Reset button on the top side of the
receiver.
3. With a sharp object, press and hold the receiver’s reset
button until you hear one short and one long beeps.
Release the reset button after the second beep.
4. Within the subsequent 20 seconds, press the (small
fl
ame button ( ) on the remote handset until you
hear two short beeps con
fi
rming the synchronization
is set.
This is a one time setting only and is not required when
changing the batteries in the remote receiver. The
remote control system is now ready to use.
Appliance’s
front panel
8. Disconnect the battery box wire if already connected.
9. Remove the cover of the battery box (1 screw).
10. Insert four AA alkaline batteries in the battery box,
re
fi
t the cover and secure with the screw.
Note: Do not put batteries in the receiver, only in
the battery box.
11. Reconnect the battery box and
place it back in its carrier.
12. Slide the carrier towards
the right hand side so
that the battery box goes
outside of the appliance
case.
13. Test the operation of the
wall switch—see page 16.
14. Fix the wall cover plate to
the outlet box.
15. Replace the receiver in its position and as well as
the antenna if deployed.
CAUTION
To avoid short-circuit to the receiver, position
the
antenna
so that it
DOES NOT TOUCH the
ignition wire.
Installation
QUALIFIED
INSTALLER