9.
There is a length of
self adhesive foam
seal supplied with the
fire. This will need to
be fitted to the outer
rear edges of the side
and top flanges of the
convector box.
Ensure that there is
no gap between the
foam seals where
they meet.
It is
important that the
bottom of the side
flanges are sealed.
10. IGNITION CHECK
Before attempting to install, it is worth checking that the ignition system performs
satisfactorily.
Remote Control (RC) Models
10.1 Fitting batteries to the remote control
handset.
The remote control handset is battery powered.
There are two 1.5 Volt Alkaline ‘AAA’ size batteries
supplied. Remove the rear battery compartment
cover from the remote control handset. Fit the
batteries in to the handset. Replace the cover.
10.2 Fitting batteries to the 6V battery box.
The gas valve and receiver are battery powered 6V.
There are four 1.5 Volt Alkaline ‘AA’ size batteries
supplied. Locate the batteries in the battery box
(NOT the receiver box)
. Remove the locking screw,
slide the battery compartment cover clear and fit the
batteries. It is important that the positive (+ve) and
negative (-ve) symbols on the battery match those of
the illustration inside the battery holder. Replace the
cover and screw.
Page 23
©
GDC Group Ltd. NOV 2017
INSTALLER GUIDE
Fitting the foam seal
