39
39
1. Re
t the window with the bottom two bolts. The
bolts should be screwed in securely.
2. Re
t the top two bolts securing by turning them
through 90 degrees.
3. Pull the top of the window forward and release to
check that it opens slightly and returns con
rming
the good function of the spring-loaded mechanism.
4. Similarly check the bottom of the window by pulling
it forward and releasing.
5. Apply light hand pressure against the window frame
sides to bed in the window seal.
6.
If the Hot Glass Warning plate has
been removed from the front lower
corner of the window, reinstall it
by sliding it between the glass and
the frame as indicated.
Remote Control Initial Set-up
Window Re
tting & Checking
IMPORTANT:
To ensure a safe operation, ensure that
the spring-loaded mechanism functions properly.
Safety warning plate
The receiver and the handset of the remote control
system must be initially synchronized before the
rst
use.
1. Insert alkaline batteries in the remote control
receiver and handset. The receiver is located left of
the control valve under the burner module.
2. With a sharp object, press and hold the receiver’s
reset button until you hear one short and one long
beeps. Release the reset button after the second
beep.
3. Within the subsequent 20 seconds, press the small
ame button ( ) on the remote handset until you
hear two short beeps con
rming the sychronization
is set.
This is a one time setting only and is not required when
changing the batteries in the remote receiver. The
remote control system is now ready to use.
QUALIFIED
INSTALLER
