Valor Horizon 534JLN, Installation & Owner'S Manual

Page: 28 / 50

28 28
Co-Linear Vent Installations
•• The chimney and  replace opening sizes are shown in
Dimensions and Location sections of this manual.
•• Place the appliance (  tted with the co-linear adapter)
near the  replace opening but allow space for
manipulating the chimney liners on to the appliance.
•• Drop the 3-inch diameter  exible liners into the
chimney from outside.
•• Fit the liners to the co-linear adapter paying attention to
inlet and exhaust and move the appliance to its proper
position. Be aware of the minimum liner bend radius
and maximum liner horizontal run shown on page 16 of
this manual.
•• Fit the termination kit and  ashing to the exterior of the
chimney.
Secure the appliance to the  oor or wall if necessary.
Rear or Top Outlet Conversion to Co-Linear Liners using Valor
556CLA Co-Linear Adapter.
(Generic co-axial to co-linear adapter boxes may also be used as an
alternate to the 556CLA).
Only for use when retro fi tting a solid-fuel burning fi replace and chimney.
The appliance must not be connected to a chimney  ue serving a separate solid-
fuel burning appliance.
Requires 556CLA Co-Axial to Co-Linear Appliance Adapter (or, alternatively, a
generic adapter), two lengths of 3-inch diameter
 exible chimney liner, co-linear termination kit and  ashing and either
high wind vertical vent terminal cap or a low pro  le vertical termination. Zero Clearance stand-offs and shields supplied
with the heater are not required for this application .
Flashing
2 x 3”
liners
3” min.
bend radius
Co-linear
adapter
2 x 3”
liners
18” max.
horizontal run
Co-linear
adapter
534
engine
Max.
40’
Approved co-linear
termination or approved
co-linear adapter
and approved
co-axial
termination
Co-Linear Venting
Co-Axial to Co-Linear Adapter
(alternate to 556CLA)
10”
10”
3” Inlet & Exhaust
Collars
7-5/8” dia.
collar
556CLA
2 x 3” Liners
26-3/4”
14”
556CLA
2 x 3” Liners
26-3/4”
14”
556CLA on
Rear Outlet
556CLA on
Top Outlet
Alternate to 559CLT/559FSK Conversion
559FSK Flashing Kit 559CLT Co-Linear Terminal
Co-Linear installation into existing F/P
556CLA Kit
Terminal Cap
Co-Linear to Co-Axial
Adapter
Flashing
QUALIFIED
INSTALLER