INSTALLER’S GUIDE
Page 25
15. SERVICING
This product uses fuel effect pieces, burner compartment walls and gaskets containing
Refractory Ceramic Fibres (RCF), which are man-made vitreous silicate fibres. Excessive
exposure to these materials may cause irritation to eyes, skin and respiratory tract.
Consequently, it is important to take care when handling these articles to ensure that the
release of dust is kept to a minimum. To ensure that the release of fibres from these RCF
articles is kept to a minimum, during installation and servicing we recommend that you
use a HEPA filtered vacuum to remove any dust and soot accumulated in and around the
fire before and after working on the fire. When replacing these articles we recommend that
the replaced items are not broken up, but are sealed within a heavy duty polythene bag,
clearly labelled as RCF waste. This is not classified as “hazardous waste” and may be
disposed of at a tipping site licensed for the disposal of industrial waste. Protective
clothing is not required when handling these articles, but we recommend you follow the
normal hygiene rules of not smoking, eating or drinking in the work area and always wash
your hands before eating or drinking.
Turn off the gas and make sure that the appliance is cool before commencing any
servicing.
Always test for gas soundness after refitting the appliance.
15.1
To Remove Outer Case.
15.1.1
Remove the knurled screws at the case sides (see figure1).
15.1.2
Pull the bottom of the case forwards and then lift the case clear.
15.2
To Remove Window Unit
15.2.1
Remove the outer case as 15.1 above.
15.2.2
Remove the window unit by detaching the 12 wing nuts securing the frame
(see figure 4) and pulling forward.
15.3
To Remove The Ceramic Fuel Items
15.3.1
Remove the outer case as 15.1 above.
15.3.2
Remove the window unit as 15.2 above
15.3.3
Remove the coals carefully
15.3.4
Lift out the coal bed
15.3.5
Replace the items as described in the installation instructions.
15.4
To Remove Burner(s)
15.4.1
Remove the outer case as 15.1 above
15.4.2
Remove the window unit as 15.2 above.
15.4.3
Remove the ceramic items as 15.3 above.
15.4.4
Remove the burner front cover by unscrewing 14 screws.
15.4.5
Remove the front ceramic support bar by unscrewing 1 screw each side.