Valor 650JN, Installation & Owner'S Manual

Page: 42 / 54

42 42
CAUTION
DO NOT USE a screwdriver or
other metallic object to remove
the batteries from the receiver or
the handset! This could cause a
short circuit to the receiver.
CAUTION
To avoid short-circuit to the
receiver, position the
antenna
so
that it
DOES NOT TOUCH the
ignition wire.
Installation
Ignition Wire Connection
(spade type connector)
Be careful when removing and
reinstallaing: not to bend or break
the spade connector
Ignition Wire
Antenna
Install Wall Switch Kit (recommended)
The wall switch kit is provided with this appliance. It is
connected to the receiver in the
fi replace. The receiver
is located left of the control valve under the burner
module.
1. Decide where the switch is to be installed. Install
an electrical outlet box or mud ring as required (not
supplied).
2. Thread the switch wire through an access hole in
the appliance.
Valve Wire Harness
Wall Switch Harness
IMPORTANT: The connection
can only be done one way.
Do not force it or damage the
pins on the receiver box!
3. Pull out the receiver box.
Remove the batteries from
the receiver box if it contains any.
You can remove
the ignition wire to improve access to the receiver.
4. Take the switch wire and plug it into the receiver’s
connection slot as indicated (the other slot should
already be
fi tted with the valve’s wire harness
connector). See diagrams below.
IMPORTANT: The connection can only be done
one way. Do not force it or damage the pins!
5. On the outside of the fi replace, run the switch wire
into the outlet box. Use insulated type staples to
secure the wiring to framing.
6. Plug the wire into the switch plate and to the outlet
box.
7. Reconnect the ignition wire to the receiver if it was
previously removed.
IMPORTANT: Make sure the ignition wire DOES
NOT TOUCH the receiver’s antenna.
8. Insert 4 AA alkaline batteries in the receiver.
Replace the cover.
9. Test the operation of the wall switch—see page 14.
10. Fix the wall cover plate to the outlet box.
11. Replace the receiver in its position and as well as
the antenna if deployed.
IMPORTANT: The antenna MUST NOT TOUCH
the ignition wire.
CAUTION
DO NOT PUT BATTERIES IN THE REMOTE
CONTROL RECEIVER
until the wires are connected
to the burner control unit as short-circuit could result
in the destruction of the electrical components
.
CAUTION
Do not run the switch wire over the top of the
fi rebox. Route the wire so it does not contact the
fi rebox.
QUALIFIED
INSTALLER