20
20
Overview
Fire On/Off Wall Switch
(supplied, recommended)
Hearth (if used) may be
combustible material.
Minimum 1/2” (13 mm) gap
required below backing plate
to surface of hearth or
fl
oor in
front for air
fl
ow. Raise enrtire
unit accordingly.
Note: Unit projects
forward of
fi
nished
wall. Allow for tile,
etc.
Backing Plate required
(sold separately)
Bezel with bar-
rier screen required
(sold separately)
650J
Field convertible
from top to rear
outlet
Framing—See Framing section
Remote Handset Wall Holder
Wall Finish
May be combustible material.
NOTE: Finished wall surface, includ-
ing tiles, etc., MUST be minimum 3/4”
(19 mm) set back from the front face
of the heater.
Combustible fram-
ing allowed beneath
fi
replace. When the
appliance is installed
directly on carpeting,
tile or other combus-
tible material other
than wood
fl
ooring,
the appliance shall be
installed on a metal or
wood panel extend-
ing the full width and
recessed depth of the
appliance.
Min.
3/4”
(19 mm)
Min. 1” (25 mm) for
combustible material
WARNING
HOT HEARTH / FLOOR! The hearth or
fl
oor
in front of the
fi
replace may become very
hot when the
fi
replace heats. Do not use the
hearth as a seat or shelf. Solid wood
fl
ooring
in front of the
fi
replace (if allowed) may
shrink during the heating season due to heat.
WARNING
Some materials or items, although safe,
may discolor, shrink, warp, crack, peel, and
so on because of the heat produced by the
fi
replace. Avoid placing candles, paintings,
photos, and other items sensitive to heat
around the
fi
replace.
!
!
QUALIFIED
INSTALLER
