4
4.
Plug the power cord into the receptacle.
Note:
Ensure you use the correct receptacle if they
are controlled separately (they should be labelled).
5.
Use the self-adhesive wire clamp provided to
secure the cable to the base of the fi replace.
Apply label
Clean the area of sheet metal liner box base adjacent
to the fan, peel the self-adhesive backing from the label
provided with the kit and apply the label to the base.
Reassemble the appliance
Reassemble the unit in reverse order and continue
with the heater installation following the installation
instructions supplied with the heater.
Apply label to
base next to fan
Receptacle
in lower
right corner
of liner box
2.
Line up the slotted holes in the fan mounting plate
with the holes in the base of the liner box and
fasten using two screws provided.
Note:
Push fan as far back as possible before
tightening screws.
3.
The thermal switch bracket is fi xed to the underside
of the fi rebox fl oor from the top. Slightly loosen the
two screws holding it and slide the thermal switch
in between the bracket and the underside of the
fi rebox fl oor. Tighten the two screws to secure the
switch in position.
Loosen 2 screws
Slide thermal
switch between
bracket and
underside of
fi rebox fl oor
Secure fan using 2 screws
1700J and 1800J appliances:
secure fan through access hole
Bottom of fi replace transparent for clarity
