36
Owner’s Information
Fireplace Control Devices
There are three ways to control your fireplace.
1.
Thermostatic Remote Control;
2.
Wall Switch;
3.
Manual On/Off Switch.
The manual On/Off switch must be ON for the fireplace
to function. It can be used to shut off the fireplace in
case of emergency.
The Thermostatic Remote Control can be programmed
to function automatically—see pages 36–38.
The Wall Switch (optional) can be used to turn on, off
and to increase or decrease the flame height—see
1265WSK—Wall Switch Kit.
Please note that the remote control in the AUTO mode
will override the wall switch.
Thermostatic Remote
Control
Wall Switch
(optional)
Manual On/Off Switch
Your fireplace remote control helps you get the comfort, convenience and aesthetics you want from your gas fireplace.
The remote controls your fireplace in different ways.
IMPORTANT:
BEFORE YOU BEGIN, please note that on this system, the settings of time, temperature and automatic
ON/OFF
can only be programmed when the function display is flashing
. Be patient when programming as it can take
a few seconds to set.
NOTE: Before using the remote control system for the first time, the receiver and the handset must be
synchronized. See the section
Initial Remote Control Set-up
on page 29 in this manual.
Turning your fireplace ON
WARNING:
When the pilot is lit, the valve motor turns
automatically to maximum flame height.
1.
Make sure that the MAN knob on the valve is in ON position.
2. Make sure that the switch on the valve is in the
I
position.
3.
Press and hold the OFF and (large flame) buttons until you hear a short acoustic
signal. Release the buttons.
The acoustic signals will continue until the pilot lights. The remote control will go
automatically into TEMP mode. The flame will be at maximum height until the remote
control reads the temperature (factory set) and will then adjust the flame accordingly.
You can put the remote in MAN manual mode, change the temperature in TEMP mode
or program your remote in TIMER mode as indicated in the following sections.
Turning your fireplace OFF
1.
Press the (small flame) button to reduce the flame to pilot.
2.
Press the OFF button to turn the pilot off.
Alternately, you can press the
O
button on the switch if you won’t use your fireplace for
a long period of time, if you cannot locate your remote control handset or if you wish to
change the batteries.
Remote Control Operation
Summary of Contents for 1200EAN
Page 40: ...40 Wiring Diagram...
