Valor 1200EAN, Installation & Operating Instructions Manual

Page: 21 / 45

21
Venting
Installation Planning
Installer—READ THIS FIRST
1. YOU NEED TO KNOW FROM THE
HOMEOWNER:
- The height of the floor or hearth finish;
- The thickness and type of the wall finish
around the firebox opening;
- What accessories (surround, door, etc.) will
be installed with this fireplace if any;
- The venting configuration.
2. Unpack the appliance.
3. Check that you have everything.
4. Finish framing.
5. Fit appliance into framing.
6. Remove overlay and fix the appliance to the floor.
7. Reinstall the overlay.
8. Install venting system.
9. Install restrictor.
10.
Connect and test gas supply.
11. Install bricks and logs.
12. Refit window.
13. Connect electrical wiring for decorative light.
14. Install optional wall switch if required.
15. Put batteries in receiver and remote control
handset.
16. Perform initial remote control set-up.
Tools and supplies required
• Packing knife
• Claw hammer
• Screwdriver set
• Metric socket set
• Pliers
• Adjustable Wrench
• Sealant
• Dish soap/water solution
• Gloves
• Eye Protection
• Dimmer Switch
• Electrical outlet box
• Electrical wire and clamp
• Cover plate for dimmer switch
17. Verify operation and adjust aeration settings.
18. Install the remote control handset wall holder.
19. Instruct the homeowner on the operation and
maintenance of the fireplace.
20. Install the window skirt.
21. Install the control access doors.
22.
Install the andirons and fret if required.
23. Finish the wall around the fireplace.
24. Install the surround/doors/mantel if required.
Roof
Pitch
Minimum
"H" (feet)
Flat to 7/12 1'
Over 7/12 to
8/12
1.5'
Over 8/12 to
9/12
2’
Over 9/12 to
10/12
2.5’
Over 10/12 to
11/12
3.25’
Over 11/12 to
12/12
4’
Over 12/12 to
14/12
5’
Vertical Vent Termination