small hole on the left hand side of the heater (See figure 7).
11.
Locate the heater in the fireplace opening, then from the front of the heater, gently
pull the steel wire on the right hand side to gather up the excess until the heater is
secure. Thread the wire through the remaining small hole to lock the wire and heater in
place (See point 4 - figure 7).
Method C - Securing with the Spacer Frame supplied with the heater.
The spacer frame is for use in installations where the chimney recess or rebate in the
surround / mantle is not deep enough to take the full depth of the heater. The minimum
rebate / depth required is 71mm.
For your safety the frame and heater must be securely fixed to the rear wall.
The rear of the spacer has two screw location
slots in the top flange. These should be to the
rear when fitting.
1.
Position the spacer frame against the wall.
Ensure that the spacer frame is central to the
fireplace.
2.
The top rear flange of the spacer frame has
two screw locations. Mark the positions of the
two screw locations on the rear wall (See figure
8).
3.
Remove the spacer frame from the fireplace
and place away from the work area.
4.
Drill the locations using a suitably sized
masonry drill bit for the wall plugs supplied.
5.
Insert two wall plugs provided into the holes.
6.
Insert a woodscrew into each hole (See
figure 4) and screw in until there is
approximately 6mm of screw protruding from
the wall.
7
. Secure the spacer frame to the heater using
four No.8 x 3/8 screws supplied (See figures 9
and 4).
8.
Carefully lift the heater and locate the slots
on the rear of the spacer frame onto the screws
in the wall. The screws can be adjusted to
ensure a tight fit. When mounting to decorative
surfaces such as wallpaper care should be
taken not to drag the heater down the wall as
this may damage the decorative surface.
Page 13
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.
Figure 9. Fitting the spacer
frame to the heater
Figure 8. Location points
Summary of Contents for 842
Page 25: ...Baxi Heating U K Limited 2008...
