MANURE CONTROL
TECHNICAN
’S MANUAL V0.
3
2020-02-19
13
5
I/O addressing
To assign input and output in the program you will need to go in schematic and look up for the
desired tag.
If you look in the schematic and you want to look to this input:
The IO Board # is
0
and input # is
10
. Input number in the program
will be
10.
The IO Board # is
1
and input # is
01
. Input number in the
program will be
101.
If you look in the schematic and you want to look to this output:
The IO Board # is
0
and output # is
13
. Output number in the
program will be
13.
The IO Board # is
1
and output # is
00
. Output number in the
program will be
100
.
In the corner of the IO tag, you will see the
Card Pin Numbe
r.
The Card Pin Number
will help you
find the cable you need in the card.
If there is a change of output address, make sure that the new equipment address is not used in
another equipment. Otherwise, the output may react strangely (Flash, remains OFF, etc.).
You need to refer to the electrical schematic to know the address of the equipment:
