Valmet Flowrox FXM Series, Installation, Operation And Maintenance Instructions

Page: 44 / 46

4FXM70EN - 8/2022
44
APPENDICES
Warranty
LIMITED WARRANTY
Your new pump is a quality product and is warranted for 24
months from date of purchase (proof of purchase is required).
The pump will be repaired or replaced at our discretion.
Pump Head and roller assembly is warrantied against damage
from chemical attack when proper TLD system instructions
and maintenance procedures are followed.
WHAT IS NOT COVERED
• Pump Tube Assemblies and rubber components – They
are ware components and require periodic replacement.
• Pump removal, or re-installation, and any related labor
charge.
• Freight to the factory, or service center.
• Pumps that have been tampered with, or in pieces.
• Damage to the pump that results from misuse,
carelessness such as chemical spills on the enclosure,
abuse, lack of maintenance, or alteration which is out of
our control.
• Pumps damaged by chemical, faulty wiring, power
surges or acts of nature.
Valmet Flow Control does not assume responsibility for
any loss, damage, or expense directly or indirectly related to
or arising out of the use of its products. Failure must have
occurred due to defect in material or workmanship and not
as a result of operation of the product other than in normal
operation as defined in the pump manual. Warranty status is
determined by the pump’s serial label and the sales invoice or
receipt. The serial label must be on the pump and legible. The
warranty status of the pump will be verified by Valmet Flow
Control or a factory authorized service center.
OTHER IMPORTANT INFORMATION
Please be advised; injection and metering devices are not
intended as a means of treating water to render it suitable for
human consumption. When used as hypochlorinators, they
are meant to destroy bacteria and algae contamination, before
its removal by filtration. Acid and soda injectors are used for
PH control (balance). FLOWROX pumps are factory tested
with water only for pressure and performance. Installers
and operators of these devices must be well informed
and aware of the precautions to be taken when injecting
various chemicals -especially those considered hazardous
or dangerous, eye protection must be worn when working
around this product or any other metering type of pump.
Should it become necessary to return the pump for repair or
service, you must attach information regarding the chemical
used as some residue may be present within the unit which
could be a hazard to service personnel. Valmet Flow Control
will not be liable for any damage that may result by the use
of chemicals with their injectors and its components. Thank
you.
PROCEDURE FOR IN WARRANTY REPAIR
Carefully pack the pump to be repaired. It is recommended
to include foot strainer since this device may be clogged and
part of the problem. Please enclose a brief description of the
problem as well as the original invoice or sales receipt, or
copy showing the date of purchase. Prepay all shipping costs.
No COD shipments they will not be accepted. Warranty
service must be performed by the factory or an authorized
service center. Damage caused by improper packaging is
the responsibility of the sender. When In-Warranty repair
or replacement is completed, the factory pays for return
shipping to the dealer or customer.
Users of electrical and electronic equipment (EEE) with
the WEEE marking per Annex IV of the WEEE Directive
must not dispose of end of life EEE as unsorted municipal
waste, but use the collection framework available to them
for the return, recycle, recovery of WEEE and minimize
any potential effects of EEE on the environment and
human health due to the presence of hazardous substances.
The WEEE marking applies only to countries within the
European Union (EU) and Norway. Appliances are labeled in
accordance with European Directive 2002/96/EC.
Contact your local waste recovery agency for a
Designated
Collection Facility
in your area.