Pag 16
4-3 Material Preparation
Sort out material sheets evenly and place on the lifting platform of the die-cutting machine. The black mark
of the material needs to be on the left side. Fix the upper left corner of the material to be aligned with the
upper left corner of the machine and use 2 magnetic plates to fix the other two sides. See picture 4-10.
< PICTURE 4-10 >
Then start the system. Click on the screen to reset and enter the number of sheet to cut. If you are using
double knives at the same time, you need to adjust the distance between the heads on the control panel.
After sending a file from a computer or reading a file from a USB flash drive, the lifting platform of the die-
cutting machine will rise till top material
’s touching the upper limit sensor. The suction belt delivers the top
sheet of material to the cutting platform automatically.
4-4 Die Cutting Preparation
Use left, right, up and down arrow keys on the control panel, make the beam focus the target sensor on the
black mark and check if the yellow light is on, as shown in Fig. 4-11. Then press OK button to start die-
cutting job.
< PICTURE 4-11 >