12
MAINTENANCE
REMOVING THE RESISTOR
To remove the resistor:
1. Disconnect the ventilation unit from the mains
electricity supply.
2. Open the doors of the unit.
3. Open the resistor box by undoing the mounting
screws (10 PZ2 screws).
4. Remove the quick connector of the resistor:
a. Press down the locking device.
b. Pull off the connector.
5. Undo the two wing nuts connecting the resistor to
the ventilation unit.
6. Lift the resistor out of the ventilation unit.
7. To reassemble the ventilation unit, follow the above
steps in reverse order.
10 x
2 x
WARNING
Risk of fire! Connect the
cables so that they do
not touch the resistor.
CAUTION
Before removing the
resistor from the unit,
make sure it is not hot.
TECHNIC
AL SPECIFIC
ATIONS
Summary of Contents for Vallox 245 MV VKL
Page 23: ...CONFORMITY CERTIFICATES...
