- 10 -
WARNINGS AND ADVICE
WARNING! Do use the machine without pro-
tection.
WARNING! A short or worn cutting wire means
a lower cutting performance so, depending
on the situation, follow the instructions for
regulating its length as indicated in the chapter
“STARTING AND STOPPING”.
Proceed calmly and carefully follow the instruc-
tions below:
- Before beginning work make sure that the area
to be cut is free of stones, debris, wires and
other foreign bodies.
- Start the machine before approaching the
grass to be cut.
- Cut grass making sure you swing the machine
from right to left and proceed slowly holding it
at on a forwards slope of approximately 30%
(Fig. F, 1).
- The grass is to be cut in layers starting from
the top (Fig. F, 2).
- Do not cut damp or wet grass.
- Do not work so that the machine is overloaded.
- Do not wear the wire by hitting against hard
objects (stones, walls, fences etc.) but use the
edge of the protection to keep the machine at
the correct distance.
- Be aware of the blade recoil and the reaction
of the blade in case it should hit against hard
objects.
- So as not to damage the extension cable, avoid
stepping on it with the machine switched on
and always keep it in a safe position behind
your back.
CUTTING DEVICE REPLACEMENT (Fig. D)
WARNING! Only use original spare parts for
replacement.
Before proceeding, please observe the compo-
nents and fig.D.
If you are not familiar with handling and assem-
bly of mechanical components, we recommend
that you contact an authorized service center.
Wear gloves to protect hands.
1) Disconnect the machine from the mains
supply.
2) Turn the machine upside down with the guard
facing upwards.
3) Replace the trimming device in the following
manner:
- With one hand hold the spool pin locked and
simultaneously press the two release keys on
the sides (Fig. D, a).
- Remove the upper bonnet (Fig. D, b) and the
empty spool (Fig. D, c) taking care to keep the
spring in its position.
- Thoroughly clean the inside of the key holder
with the aid of a small brush.
- Insert the new spool in the cuff, inserting the
ends of the wires into the appropriate holes
(Fig. D, e-f)
- Insert the cap on the spool pin and restore
the length of the cutting line following the
operations described in the STARTING AND
STOPPING chapter.
WARNING! Do not use makeshift trimming
systems by re-using worn originals. Use only
approved replacements. The use of line with
different characteristics to those of the original
can permanently damage the machine as well
as annulling the terms of the guarantee.
MAINTENANCE
WARNING! Before checking or carrying out
maintenance on the machine, disconnect it
from the power supply.
WARNING! The wire cutter may cause deep
cuts.
- Clean and maintain your machine regularly, to
ensure that it remains perfectly efficient and
has a long working life.
- After every cutting process, clean the cutting
device and protection so that they are free from
grass and earth.
- During use, keep motor ventilation grids clean
and free from grass.
- Clean the machine with a soft brush or cloth.
- Do not wet or spray water over the tool.
- Do not use any detergents or solvents as
these may damage the machine beyond re-
pair. Chemical agents can easily damage the
plastic parts.
- If the wire cutter breaks, contact an authorised
service centre.
