- 19 -
detergents or solvents as these may damage
the machine beyond repair. The plastic parts
can easily be damaged by chemical agents.
- Do not use compressed air for cleaning: Risk
of flying chips and splinters!
- Pay the utmost attention when cleaning the
switch, engine fan slots, blade, adjustment
knobs, work surface, work surface insert and
dust blowing tube.
For your safety, periodically check the condi-
tions of the following components. Replace
them if damaged or worn:
- switch (pos. 12)
- blade (pos. 5)
- blade guard (pos. 14)
- exhaust manifold (pos. 16)
- work surface plastic insert (pos. 13)
- power supply plug and cable (pos. 23)
LUBRICATION
At the points indicated in Fig. A with the bottle
symbol, lubricate the bushings on the fixed
upper arm (pos. 7) on both sides with a few
drops of oil.
- at first use
- after 5 hours of use
- then every 10 hours of use.
Remove any excess oil with a cloth.
PAIR OF BRUSHES (if applicable)
The engine of this machine is equipped with a
pair of graphite brushes. They must be checked
and replaced by an authorised service centre.
FUSE (if applicable)
This machine’s electric circuit may include a
fuse protection.
To check fuse conditions or to replace it, ma-
nually unscrew the “FUSE” cap (pos. 20) next
to the speed regulator.
Replace the fuse with one of equal characteri-
stics and dimensions; insert the fuse in the cap
housing and screw it into the threaded hole.
TROUBLESHOOTING AND PERMITTED
OPERATIONS
THE MACHINE DOES NOT START OR IT STOPS
AND DOES NOT RESTART:
No power:
- Make sure the power cord and extension (if
applicable) are not damaged.
- Check the power supply system’s main switch.
- Check the fuse (pos.20 fig.A)
Worn graphite brushes (if applicable):
- Contact an authorised assistance centre.
Electrical fault:
- Contact an authorised assistance centre.
THE MACHINE VIBRATES EXCESSIVELY:
Dull, damaged or deformed blade:
- Replace the blade.
Incorrectly assembled blade:
- Remove the blade and reassemble it correctly
following the instructions
Machine insufficiently secured to the bench:
- Improve machine fastening.
THE MACHINE HAS TROUBLE CUTTING:
Dull or damaged blade:
- Replace the blade.
THE DUST BLOWING DEVICE DOES NOT WORK:
Tube bent:
- Straighten the tube.
Tube or distributor clogged:
- Clean
Pump broken:
- Contact an authorised assistance centre.
!
!
WARNING! If the machine still fails to fun-
ction correctly after you have carried out the
above operations, or in the event of anomalies
other than those described above, turn the ma-
chine off and take it to an authorised service
centre or have an authorised technician repair
it with original spare parts. Always provide the
machine model and serial number shown on
the technical data label.
