- 12 -
INSTALLATION
!
!
IMPORTANT! The manufacturer is not
liable for any direct and/or indirect damage
caused by incorrect connections.
!
!
IMPORTANT! Before carrying out the fol-
lowing operations, make sure that the plug is
disconnected from the mains.
TRANSPORT
Always use the packaging when transporting the
vacuum cleaner; this will protect it from impact,
dust and humidity which can compromise its
normal operation.
MOVING
Hold the tool by the hand grip and after use put
it down upright without banging it.
STARTING UP
When choosing where to use the electrical vacu-
um cleaner, the following should be considered:
- that the place is not damp and is protected
from the elements.
- that there should be a large operational area free
from obstacles.
- that there needs to be good lighting.
- that there is sufficient air exchange.
- that it needs to be used close to the general
differential switch.
- Check that the power supply is in compliance
with the regulations in force..
- that the room temperature should be between
10° and 35°C.
- that the environment is not in an explosive
atmosphere.
The machine may be supplied with some loose
components. Take the machine and the loose
components out of the packaging and proceed
to assemble them as shown in fig. A-C.
FILTER ASSEMBLY (fig. C).
Always to be installed.
Insert the sponge filter (pos.27), then assemble
the filter (pos.22) on the filter support as indi-
cated in the figure, making sure the seal sticks
well. Take care not to damage the float (pos.26)
or obstruct its upwards movement.
ASSEMBLING THE VACUUM HEAD (fig.A)
After assembling the filter or the dust bag, insert
the vacuum head (pos.2) on the collection box,
making sure the side latches match up with the
housings on the vacuum head.
If present, match up the 2 reference arrows:
one on the vacuum head and the other on the
outside of the box.
Lock the vacuum head in place with the latches
(pos.7).
ASSEMBLING THE VACUUM HOSE (fig.A)
- Insert the sleeve (pos.9) of the hose in the
vacuum connection (pos.3) by pressing and
turning.
Insert the rigid vacuum pipe (pos.8) and the
vacuum nozzle (pos.24) on the sleeve (pos.10).
STARTING AND STOPPING (FIG.A)
!
!
IMPORTANT! Make sure nobody is ap-
proaching the working area while the tool is
running.
Starting
1) Plug the machine into the power supply.
2) Hold onto the hand grip firmly (pos.10)
3) With the other hand press the start button
(pos.1) to “ON” “I”.
Stopping
To stop press the switch button to “OFF” “O”.
We recommend repeating these operations
several times before starting work, in order to
familiarise yourself with the controls as far as
possible.
If you notice any working defects, switch off
the electrical vacuum cleaner and consult the
chapter “Problem, causes and solutions”.
When not using the machine, turn it off and
disconnect the plug from the socket.
