4
Top interface introduction
20
13
14 15
16
16
17
17
18 19
19
twenty one
twenty one
twenty two twenty three
twenty four
13.-EXP/FS
1/4"-TRS connector, used to connect external expression pedals or foot spikes.
19.-BALANCED-OUTPUT
Use balanced cables with XLR connectors to connect to the recording room equipment,
Tuner or full-range playback device.
When using only one speaker, please first select the connection to
L(MONO) connection.
14.-INPUT-
1/4"-mono connector to connect guitars, music or other musical instruments.
15.-AUX-IN-
The 1/8"-stereo interface is used to connect an external device (CD
player or MP3 player) for practice, improvisation or recording.
20.-PHONES-
The 1/8"-stereophonic connector can be used with earphones with an
impedance of 60 ohms or less.
16.-SEND/RETURN
This set of 1/4-connectors provides the function of an effect loop, which
can connect the effects of other effectors to the GP-200.
21.-MIDI
This interface is used to connect external MIDI devices.
22.-USB
The USB-2.0-Type-C interface supports multiple operating systems,
provides high-quality sound card functions, and provides rich
MIDI function.
17.-UNBALANCED-OUTPUT
1/4"-non-balanced output connector, can be configured as mono or
stereo. Use them to connect to a single guitar cabinet, a pair of speakers
Acoustic guitar box, or directly connected to the input of a PA or recording device
入.
23.-POWER-
Used to turn on/off the power of GP-200.
18.-GND/LIFT-switch-
Press the GND/LIFT switch to cut off the ground connection (Ground-
Lift) of the two XLR connectors to avoid noise caused by the ground
loop (Ground-Loop). Lift the GND/LIFT switch to make the XLR
connection The ground wire is connected normally.
24.-DC-9V
The specification of the power supply used is 9V-1000mA DC power supply, the polarity is negative inside and
positive outside.
Get up quickly
1.-Connect your device. Plug your guitar into the input connector of the GP-200, and connect your sound box to the output connector.
-
Warm mention:-
Ÿ
Ÿ
2.-Connect the power supply and turn on the GP-200.
-
3.- String calibration. Step on the TAP spike to turn on the tuner. Pluck each string, the tune turns to green in the middle of the screen. When all the strings have been tuned, follow the
screen prompts to exit the tuner function.
-
Turn down the volume of the amplifier.
-
Connect the cable to the Return connector of the FX circuit of the guitar box for the best effect.
"Please refer to page 16 for the connection method."
-
