Valeo CC 305, Owner'S Manual

Page: 38 / 50

1.9- Heating by Conveyors *
1.10- Air Refreshening
1.11- Internal and External Temperature
1.8- Heating Mode
1.7- Cooling Mode
After selecting the ‘automatic mode’ according to item 1.5 and if the internal
temperature of the vehicle is above the set-point, the equipment will start to
operate in ‘cooling mode’ automatically.
Whenever the system starts up in ‘cooling mode’ the evaporator fans will start
on ‘automatic mode’. However, the ventilation speeds may be changed
manually (see item 1.6).
Note: in the ‘automatic mode’, the evaporator blowers are activated according
to the set-point programmed.
1 – After selecting the ‘automatic mode’ according to item 1.5, and if the
internal temperature of the vehicle is below set-point, the equipment will
begin operating in 'roof-heating mode'.
Note: in this mode, the ventilation will operate only at low speed.
The ‘heating by conveyors mode’ is activated in the same way as the
‘roof-heating mode’.
* Conveyors – Heating coils installed by the body manufacturers. The are
normally located along the side of the passengers' saloon, below the seat.
1 – With the air conditioner running on ‘automatic mode’, the air-refreshening
will work according to the set-point temperature so as to find a comfortable
condition for passengers.
This applies to both ‘cooling mode’ and ‘heating mode’.
a) The indicator (11) will turn on to inform when the air-refreshener is open and
turn off to show that it is closed.
2 – During cooling or heating, the air-refreshener can be manually activated by
pressing the key (RENOV). It will stay open for 10 seconds. After this, it will close
automatically and go back to the automatic cycle.
Note: in the event of the air-refreshener being open when the ‘cooling mode’
starts operating, it will shut automatically.
The display will normally show the inside temperature of the bus.
1 – To verify the external temperature, press the key (TEMP). The display will
then show the outside temperature for 5 seconds. While the external
temperature is shown on the display, the indicator (13) will be on.
After 5 seconds the display will go back to showing the internal temperature
and the indicator (13) will be off.
If the key (TEMP) is pressed before the pre-determined period of 5 seconds, the
display will show the internal temperature again.
CC 305 - CC 335 - CC 355 OPERATING THE AIR CONDITIONER
38