Valentin WMX 5001, Operating Manual

Page: 13 / 32

Wipe-On Applicators Installation
10.23 Operating Manual 13
4 Installation
4.1 Unpack the Wipe-On Applicator

Lift the wipe-on applicator out of the box.

Check the wipe-on applicator for transport damages.

Check delivery for completeness.
4.2 Scope of Delivery
•
Wipe-on applicator
•
2x holding shaft (length 300 mm).
•
1x mounting angle
•
4x cylinder screw M5x12
•
4x washer
•
Documentation
NOTICE!
Retain original packaging for subsequent transport.
4.3 Connect the Transducer to Printing System
The use of the printing system with wipe-on applicator requires the
utilization of an external start signal.
E.g. the optionally available product sensor for the external start signal
can be attached to the printing system
For detailed information refer to chapter 6.1, page 25).