24V BACA
OPERATION MANUAL
5
AUS
1300 734 253 NZ 0800 734 253
CONNECTING THE TESTER TO THE
BATTERY
After connecting the tester to the battery, you can view the software version and the serial number of the tester for a few
seconds. After this, the voltage of the battery is displayed. Ensure the USB is connected to the tester before you start
programming the tester. The tester will not run a test without a USB connected to it.
Menu System
The main menu consists of 6 screens. You can change between the screens using the DISPLAY CHANGE button.
1 Voltage Screen
Voltage
12.8V
2 Test Parameter Screen
Test parameters
3 Read Test Results
Read test result
4 Charge
Charge
5 Discharge
Discharge
6 Pendrive Suspend
PNDRV Susp
Setting the Test Parameters
To set the test parameters, you have to switch to the test parameters screen and press the START/STOP button. This
submenu consists of 5 different screens. You can change between the screens by pressing the DISPLAY CHANGE button.
In order to change the values, use the UP and DOWN buttons. If you keep the UP/DOWN button pushed, the values change
rapidly.
First, you can set the desired number of cycles.
Number of cycles
1
Enter
You can change the values 1-200 by pressing the UP/DOWN button.
