6. WARRANTY & REPAIR
Valcom, Inc. warrants its products to be free from defects in materials and workmanship under
conditions of normal use and service for a period of one year from the date of shipment. The
obligation under this warranty shall be limited to the replacement, repair or refund of any such
device within the warranty period, provided that:
1.
Inspection by Valcom, Inc., indicates the validity of the claim.
2.
The defect is not the result of damage, misuse, or negligence after the original shipment.
3.
The product has not been altered in any way or repaired by others and that factory sealed
units are unopened. (A service charge plus parts and labor will be applied to units defaced
or physically damaged).
4.
All units 'out of warranty' are subject to a service charge. The service charge will cover
minor repairs (Major repairs will be subject to additional charges for parts and labor).
This warranty is in lieu of and excludes all other warranties, expressed or implied, and in no
event shall Valcom, Inc. be liable for any anticipated profits, consequential damages, loss of time
or other losses incurred by the buyer in connection with the purchase, operation or use of the
product.
This warranty specifically excludes damage in shipment. In the event a product is received in
damaged condition, the carrier should be notified immediately. Claims for such damage should
be filed with the carrier involved in accordance with the F.O.B point.
2. INSTALLATION:
This section provides complete instructions for mounting the V-9982. Before you install the V-
9982 system, make sure you have:
- A message or music on hold input connection/jack on your phone system.
- A non-switchable 110VAC electrical outlet near the location where the unit is to be installed.
2.1.
Wall or Table Installation:
1.
Locate a proper space on the telephone equipment board or wall. You can mount the
V-9982 unit in one of three positions: flat, side, or horizontal. See illustration below.
2.
Position the unit on the board; mark the mounting hole locations
3.
Using the mounting screws provided, secure the V-9982 system to the board or wall.
4.
If table top mounting the V-9982, stick the enclosed rubber feet on the bottom of the
unit.
2.2.
Connecting Power:
1.
Plug the power plug into the V-9982 system's power jack marked POWER.
2.
Plug the power pack into a 110VAC power outlet which is not connected to a switch.
3.
There is no power switch on the V-9982 system, so as soon as power is connected, the
system will be active.
2.3. Connection to Telephone Equipment:
1.
Connect one side of the supplied RCA cable to the telephone equipment's Message-On-
Hold input. Connect the other side of this cable to the V-9982's LINE OUT. There are
two audio outputs on the V-9982, LINE OUT(Low, +4dB into 600 ohms), and SPKR
OUT(High, 1.5W into 8 ohms). Use the LINE OUT first adjusting the audio output vol-
ume potentiometer to obtain the correct audio level. If this does not provide enough
audio level, then switch to the SPKR OUT.
12
V-9982 Owner’s Manual
V-9982 Owner’s Manual
5
Headquarters Valcom, Inc
5614 Hollins Road
Roanoke, Virginia USA 24019
Tel: (540) 563-2000
Fax: (540) 362-9800
In Canada CMX Corporation
35 Van Kirk Drive #11 & #12
Brampton, Ontario L7A 1A5
Tel: (905) 456-1072
Fax: (905) 456-2269
