4
Page and Music Level Set-up
The V-1109RTHF has volume controls for the
following functions:
•
Speaker to phone
•
Phone to speaker
•
All Call master control
•
Background music input control Zones 1-5
•
Background music input control Zones 6-9
Refer to Figure 7 for volume control locations.
Control Set-Up:
1. Set-up Talkback Controls:
(a)
The phone to speake r level should be at a
normal listening level.
(b)
Speaker to phone level: This is the most
critical level; set the volume at the lowest
practical level (it is better to set it too low,
than too high).
2. All Call Level:
The All call level should be set to produce the
same audio level as the phone to speaker page
control.
3. Background Music Levels:
There are two volume controls provided for
background music adjustments: Zones 1-5 and
Zones 6-9.
It is important that the two background music
controls be used to set the music levels in the system.
Adjust these controls after all other system volume
levels have been set.
Repeat Alert Tone
A wire jumper controls the 15 seconds alert tone. The
repeat alert tone is disabled when the jumper is in
place and is enabled by cutting or removing the
jumper.
BACKGROUND MUSIC
CONTROL ZONES 1-5
BACKGROUND MUSIC
CONTROL ZONES 6-9
ONE-WAY ALL CALL
VOLUME
50 PIN MALE
CONNECTOR
SPK-TO-PHONE
TURN CLOCKWISE
TO INCREASE
RECEIVE VOLUME
PHONE-TO-SPK
TURN CLOCKWISE
TO INCREASE
TRANSMIT VOLUME
Figure 7 - User Control Locations
OPERATION
General Description
To make a voice page, go off-hook and dial the
number of the desired zone or station. Dial tone will
be broken after the first number is dialed. A one
second ringback tone will indicate that the called zone
is being signaled. After the tone, proceed with the
page. If using talkback speakers, the called party may
answer handsfree. If speaker cancel is wired when
called party goes off hook, speaker will be turned off.
Personal signaling: When initiating a call, depress the
"*" and then the station number. A double tone will
be sent to the called speaker. No voice announce or
talkback will be possible.
To dial a new number (tone dial only), depress the "#"
button. The speaker for the first number will be
disconnected and dial tone returned to calling party.
Dial new number and page.
NOTE: If "#" is depressed after the speakers have
been inhibited, additional numbers may still be dialed.
A tone will signal the called party but no voice
announce or talkback will be possible.
User Instructions
In order to achieve maximum performance from this
system, the user should receive the following
operating instructions.
A.
The calling party should speak directly into
telephone mouthpiece and avoid speaking too
softly.
B.
The called party must wait (approximately 1/2
second) before responding to the calling party.
