MUS0920201
07/10/2014 18
MELTON, S.L.U. - POLIGONO INDUSTRIAL AGUSTINOS CALLE G-34,31160 ORCOYEN, NAVARRA
TEL: 00 34 948 321580 Fax: 00 34 948 326584 e-mail: [email protected]
3.1. INTRODUCTION:
This chapter explains how to install the machine correctly.
WARNING: The operations described in this chapter should be
performed by qualified personnel, following the safety
instructions.
3.2. TRANSPORT:
The machine is supplied on a pallet with a wooden frame.
Remove the top and front covers to unpack.
Unpack carefully to prevent damage to the machine. Inspect the
machine for damages caused during transport.
3.3 INSTALLATION REQUIREMENTS:
Install the ISOMELT machine leaving enough space for it to be accessed during
operations.
Avoid extreme temperatures (below -10ºC and above +50ºC).
Try to avoid installing the machine where there are draughts. If this is not possible,
the guns will need to be protected because they may not work properly if the
temperature suddenly drops.
